I need to make my own cables...but I'm kinda nervous because I'm not much with a saudering iron.

Where should I start as far as making my own mogami cables and jacks?

BTW, I'm also doing this same mod to my Marshall AVT 50 combo...since I use that the most when I practice...and I found quite a few places where air was escaping actually.

On top of the speaker cables, I want to make an angled 1/4'' input to the dual disconnects for the single speaker in that combo....gimme some insight dammmmit.


I also had an idea about somrething else.

Would using fasteners like these: SUPERLOCK FASTENERS be a good substitution for the rubber feet on my head?

I read somewhere about the vibration of the head affects the tone blah blah...but I'm not sure.

__________________